A3 Sportback &gt; A3 &gt; Audi Ireland

Technical Data

Show all information Show less information

A3 Sportback with SE 30 TFSI 6-speed

Motor

Engine Type

Engine-Management

Emission Control System

Power

Displacement

Max. Output

Max. Torque

Electric drive

Maximum torque

Maximum torque front/rear

Total system torque output

Total system power output briefly

Battery type

Gross battery capacity

Usable battery capacity

Maximum electrical power

Max. charging capacity AC / HPC

Max. charging capacity AC

Charging time 0 – 100% at max. charging capacity AC (approximate value)

Min. charging time 5 – 80% at max. charging capacity HPC

Min. charging time 10 – 80% at max. charging capacity HPC

Max. chargeable energy content in 10 min at max. charging capacity / resulting max. additional range (WLTP)

Driveline

Transmission Type

Clutch

Gearbox

Chassis

Front Axle

Rear Axle

Tyres

Wheels

Brake System

Brakes

Steering

Steering

Weights

Unladen Weight

Gross Weight Limit

Roof Load Limit

Trailer weight limit

unbraked

at 12% gradient

at 8% gradient

Volumes

luggage compartment capacity

Fuel tank (approx.)

Fuel tank (approx.)

Performance

Top Speed

Acceleration 0-100 km/h

The specified fuel consumption and emission data have been determined according to the measurement procedures prescribed by law. Since 1st September 2017, certain new vehicles are already being type-approved according to the Worldwide Harmonized Light Vehicles Test Procedure (WLTP), a more realistic test procedure for measuring fuel consumption and CO2 emissions. On September 1st 2018, the New European Driving Cycle (NEDC) was replaced by the WLTP in stages. Owing to the more realistic test conditions, the fuel consumption and CO2 emissions measured according to the WLTP will, in many cases, be higher than those measured according to the NEDC. Therefore, the usage of CO2 emission values measured according to WLTP for vehicle taxation from 1st September 2018 on can cause changes in this regard as well. For further information on the differences between the WLTP and NEDC, please visit www.audi.de/wltp or https://www.audi.ie/ie/web/en/models/layer/wltp-lp/layer/nefz-wltp.html

We are currently still required by law to state the NEDC figures. In the case of new vehicles which have been type-approved according to the WLTP, the NEDC figures are derived from the WLTP data. It is possible to specify the WLTP figures voluntarily in addition until such times as this is required by law. In cases where the NEDC figures are specified as value ranges, these do not refer to a particular individual vehicle and do not constitute part of the sales offering. They are intended exclusively as a means of comparison between different vehicle types. Additional equipment and accessories (e.g. add-on parts, different tyre formats, etc.) may change the relevant vehicle parameters, such as weight, rolling resistance and aerodynamics, and, in conjunction with weather and traffic conditions and individual driving style, may affect fuel consumption, electrical power consumption, CO2 emissions and the performance figures for the vehicle. Further information on official fuel consumption figures and the official specific CO₂ emissions of new passenger cars can be found in the guide “Information on the fuel consumption, CO₂ emissions and electricity consumption of new cars”, which is available free of charge at all sales dealerships and from DAT Deutsche Automobil Treuhand GmbH, Hellmuth-Hirth-Strasse 1, 73760 Ostfildern-Scharnhausen, Germany (www.dat.de).